2 Operator interface
2.7 “Extras” screen
BreakerVisu
06/16 MN01210001Z-EN
www.eaton.com
27
Figure 20:“Extras” screen 1 (7“ variant)
Table 21: Controls in “Extras” screen 1 – Navigation (7“ variant)
Table 22: Controls in "Extras" screen 1 – Networks (7" variant)
Control
Action
There are two
Extras
screens.
To get to the second screen, tap the
Next page
button.
Control
Action
Tap the
Discover Devices
button to search for SmartWire-DT
devices. The
SWD Settings
will show basic information
regarding the connected devices and the SmartWire-DT
network's status (number of active measuring devices on the
network and actual SmartWire-DT status).
The Modbus RTU information pane features buttons that you
can use to configure basic communication parameters: the
number of stop bits (
1 bit / 2 bits
button), the baud rate (
9600 /
19200 / 38400
button), and the parity (
no / odd / even
button).
The selected values will be shown to the right of the
corresponding buttons.
Tap the
Discover Devices
button to start scanning the
Modbus RTU network for connected devices.
Tap the
Available Device Types
button to open a table
listing the device types supported by the BreakerVisu program.
This table will contain four Eaton device types and four
configurable device types that can be used for 3rd party
devices.
Note:
The ability to use configurable device types is an optional
BreakerVisu program feature that requires a license.
Additional information
Summary of Contents for BreakerVisu NZM-XMC-MDISP35-MOD
Page 4: ...2...
