Eaton APS3-400 Series, Installation And Operation Manual

Page: 40 / 114

Access Power Solutions Installation Guide (APS3-400 Series)
34
Copyright © 2007-2010 Eaton Corporation. All Rights Reserved.
IPN 997-00012-52D July 2010
Start-Up Tasks
Complete all the Installation tasks (see details on page 14 ) before starting these Start-Up tasks.
Complete the Start-Up tasks in the following order:
Task Description Reference
1 Insert the Rectifiers See details on page 34
2 Complete the Pre-Power-Up Checklist See details on page 35
3 Apply AC Power See details on page 35
4 Configure the dc power system See details on page 36
5 Apply DC Power to Battery and Load See details on page 37
Task 1 - Inserting the Rectifiers
•
Do NOT install the rectifiers until the room has been cleaned and is dust free.
•
Do NOT switch on the ac supply at this stage.
Step 1 - Unpack the rectifiers
Unpack the rectifiers and inspect them carefully for possible transport damage.
Report any damage immediately using a completed Equipment Incident Report on
page
101 .
‡
Keep the original packaging to return a rectifier for replacement or repair, if required.
Step 2 - Fit first rectifier
1
Align the rectifier with the left side of the shelf.
2
Push in the rectifier until the retaining screw contacts the shelf.
3
Check the rectifier's rear connector is correctly aligned with the shelf connector,
or damage may occur.
4
Tighten the retaining screw to 1.5Nm (13.3 inch-pounds). This will locate the
rectifier in its rear connector.