Eaton 9395C-1000/1000, Installation And Operation Manual

Page: 36 / 156

UPS Installation Plan and Unpacking
3-12 Eaton
®
Power Xpert
®
9395C UPS Installation and Operation Manual P-164000821—Rev 01 www.eaton.com/powerquality
Conduit sizes Conduit sizes were chosen from NEC Table 4, Electrical Metallic Tubing (EMT). See Table 3-10
for conduit requirements.
Per NEC article 300, 3(B)(1), all three-phase conductors must be run in the same conduit.
Conduit is sized to accommodate one ground conductor sized in accordance with NEC Table 250.122.
DC Input from Battery or
Battery Disconnect to UPS
E4 Battery (+) 16 – 2 bolt mounting 76 (56) M12
E5 Battery (-) 16 – 2 bolt mounting 76 (56) M12
NOTE Customer ground, sized in accordance with NEC Table 250.122, can be run in any conduit listed in Table 3-10.
Table 3-8. Supplied External Wiring Terminal Hardware Kit
Part Size Quantity Terminals Used On Eaton Part Number
Bolt, Grade 5 M10 x 40 mm 30 Ground and Neutral 180190078-088
Bolt, Grade 5 M12 x 50 mm 86
Rectifier Input, Bypass Input,
Battery Input, and Output
180190078-115
Flat Washer M12 52
Rectifier Input, Bypass Input,
Battery Input, and Output
180500036-120
Conical Washer M12 26
Rectifier Input, Bypass Input,
Battery Input, and Output
180500037-120
Nut M12 26
Rectifier Input, Bypass Input,
Battery Input, and Output
180200001-07
Table 3-9. Recommended Installation Parts and Tools (Not Supplied by Eaton)
Part Size Quantity Manufacturer Part Number Notes
Long Barrel 2-Hole Lug
2/0 AWG
As required
Thomas & Betts 54862BE
Copper wire only
3/0 AWG Thomas & Betts 54864BE
4/0 AWG Thomas & Betts 54866BE
250 MCM Thomas & Betts 54868BE
300 MCM Thomas & Betts 54870BE
350 MCM Thomas & Betts 54872BE
400 MCM Thomas & Betts 54874BE
500 MCM Thomas & Betts 54876BE
Manual Hydraulic Crimp Tool 14 Ton 1 Thomas & Betts TBM14M
Die Set N/A 1 Thomas & Betts 15506
Table 3-7. UPS External Power Cable Terminations
Terminal Function Terminal Function
Bus Landings
(using both sides of bus)
Tightening Torque
Nm (lb ft)
Bolt Size