9130 firmware upgrade guide
1028349 Rev. P4
2012, Eaton Corporation
Page 6 of 11
7.
Press
button when the following Popup Message Box
should appear:
Note.
If the message below will appear instead, return to item 1 in this
procedure to verify the cabling, COM port settings and that the UPS is in
standby state.
8.
Unplug the input power cord from the UPS and click
. The
flashing will begin after a few seconds.
Note.
If “Flash firmware NG!” message will appear during the flashing, go
to Chapter
1.3 DSP Firmware Upgrading via RS-232 – Flash Error
.