9
614-06819-00
(For further information, visit the www.powerquality.eaton.com site or contact after-sales support.)
Problem
Diagnostic
Solution
1
•
The battery backup outlets
19
are not supplied with power.
•
Button
6
is not lighted on.
•
Press button
6
and check that
it turns green.
2
•
The connected devices are not
supplied when AC power fails.
•
The devices are not connected
to the battery backup outlets
19
.
•
Connect the devices to the
battery backup outlets
19
.
3
•
AC power is available, but the
UPS operates on battery power.
•
Circuit breaker
20
, located
under the UPS, has been tripped
by an overload on the UPS
output.
•
Disconnect excess equipment
and reset the circuit breaker
20
by pressing the corresponding
button.
4
•
Green button
6
flashes and
audio alarm beeps every 3
seconds.
•
The UPS battery backup outlets
19
are overloaded.
•
Disconnect excess equipment
connected to the battery backup
outlets
19
.
5
•
Fault sign
12
appear on the
LCD panel and audio alarm beep
continuously.
•
A fault has occurred on the UPS.
The battery backup outlets
19
are
no longer supplied.
•
Call after-sales support.
6
•
EcoControl outlets keep powered
when main application (Master
outlet) is stopped.
•
EcoControl function is not
activated or not properly set.
•
Activate or set properly
EcoControl function using the
software provided with the
product.
8. Troubleshooting
AC-power disturbance
•
If AC power is disturbed or fails, the UPS continues to operate on battery power.
Button
6
flashes green. In normal mode, the audio alarm beeps every ten seconds,
then every three seconds when the end of battery backup time is near. In silent mode
(see the section on settings), the audio alarm simply beeps once when the UPS
transfers to battery power.
•
If the power outage lasts longer than the battery backup time, the UPS shuts down
and automatically restarts when power is restored. Following a complete discharge, a
few hours are required to recharge the battery back to full backup time.
•
To save battery power, it is possible to press button
6
to cut the supply of power to
the devices connected to the battery backup outlets.
Lightning protection:
All outlets, whether backed up or simply filtered, include surge protection, whatever the
position of button
6
.
Shutdown of the battery backup outlets 19
Press button
6
for more than two seconds.
