HOW TO OPERATE YOUR GETFIT SCALE
Before First Use
1. Inserting Batteries and Selecting Measurement Unit
a) Open the battery compartment door on the back of the scale.
b) Put the batteries in, flat end against the spring. The LCD will display.
c) Close the battery door and wait until
is shown on the LCD.
d) Press “UNIT” button (located underneath scale) to select the desired measurement
unit; pounds, kilograms, or stones. To set the scale to pounds, you want the display
to read lb only (not st lb for stone pounds – a British measurement system). The
default setting is pounds.
Weight Operation Instruction Only
1. Calibration
Place the scale on a hard, flat surface. After placing the scale down the display may read
~4 lbs briefly then it will go to 0 (zero). If you do not see the 4 lbs briefly register, press
down on the scale platform to activate the backlight, get off, and wait for it to shut off. You
can then step on the scale and get an accurate reading.
2. Weight Reading
Step on the scale, placing both feet evenly on each side and standing as still as possible.
After a few seconds, you will see the weight flash three times to indicate a weight reading
has been calculated.
Your Precision GetFit operates via “Step-On” technology but still needs to be calibrated upon first use or after the
scale is moved to ensure accuracy.
After installing batteries, immediately place the scale on solid, flat surface (avoid carpet or softer flooring).
1.
If the scale is on when it is placed on the floor you should see the scale read ~4lbs for 3 seconds then go
to 0.0. Your scale is now calibrated and ready for use
2.
If the scale does not turn on when placed down press the glass platform with one foot to turn the scale on
(but do not step on fully). Allow the scale to go to 0.0 and turn off.
Note: When you pick up the scale, move the scale or replace batteries, the scale may lose calibration. You can
either recalibrate (see above) or disregard the first weight after the scale is moved.
