background image

Adjusting the tension on the Vario 5

If you have a Vario 5, adjust the power 

pack to match your camera setup. 

While adjusting the tension of the power 

pack make sure to lock the arm or 

hold it at the lowest position to avoid 

interference from the STABIL G3.

For further details please read the Vario 

5 user manual.

Adjusting the tension on the STABIL G3

Increase the tension of the spring by turning 

the knob clockwise. The Easyrig STABIL G3 

can stabilize camera setup weights between 

5-25 kg (11-55 lbs) but is limited to the 

maximum weight capacity of the power pack 

it is combined with. 

The Easyrig STABIL G3 is adjusted correctly 

if the arm is resting between the lowest and 

highest position when a camera or gimbal is 

attached. 

For setup video go to www.easyrig.se -> 

Support -> Service Videos & Manuals

Turn page

1

2

3

Easyrig STABIL G3

Set up:

1. Assemble the STABIL G3 top bar into 

the Vario power pack by sliding the guide 

post into the line hole of the Vario power 

pack or standard Cinema power bar.

2. While holding the base of the STABIL 

G3 grab the folded front bar and lift 

upwards until the bar slides in completely 

flush. Keep hands clear of the connection 

joint to avoid injury.
Compacting:

Fold the top arm against the STABIL G3 

base by pulling the front bar completely 

forward and then down. Pull the whole arm 

and fold into the vest.

Design Protection USA / EU / INDIA / CHINA: 

DM/203947, 79612 & (ZL)201930512717.8
Trademark USA / EU / INDIA / CHINA: Pending

Reviews: