Plumbing:
Connect with pipe and fittings that are the same size or larger than threaded ports.
Be sure to connect the intake and exhaust plumbing to the correct inlet and outlet ports.
Accessories:
Check filters periodically and replace when necessary. Install relief and gauges at inlet or
outlet or both, to monitor performance. Check valves may be required to prevent back
flow through pump.
Electrical:
WARNING! Electrical Shock Hazard. This product must be properly grounded.
Do not modify the plug provided. If it will not fit the outlet, have the proper outlet
installed by a qualified electrician. If repair or replacement of the cord or plug is
necessary, do not connect the grounding wire to either flat blade terminal. Check the
condition of the power supply wiring. Do not permanently connect this product to wiring
that is not in good condition or is inadequate for the requirements of this product.
Failure to follow these instructions can result in death, fire or electrical shock.
All electrical work must be performed by a qualified technician. Always follow the
National Electric Code (NEC) or the Canadian Electrical Code as well as all local, state
and provincial electrical codes. Code questions should be directed to your local electrical
inspector.
VERIFY: Make sure that power supply agrees with that listed on the product nameplate.
All cords with plugs must be plugged into an outlet that is properly installed and
grounded in accordance with all local codes and ordinances. Hard wired installations
must be connected to a grounded, metallic, permanent wiring system or equipment
grounding terminal or lead on the product.
Operation:
WARNING! Injury Hazard. Install proper safety guards as needed. Keep fingers and
objects away from openings and rotating parts. When provided, motor terminal
covers must be in place for safe operation. Product surfaces become very hot
during operation, allow surfaces to cool before handling. Air stream from product may
contain solid or liquid material that can result in eye or skin damage, wear proper eye
protection. Wear hearing protection. Failure to follow these instructions can result in
burns, eye injury, or other serious injury.
Start Up
If motor fails to start or slows down significantly under load, shut off and disconnect from
power supply. Check that the supply voltage is correct and verify motor is turning proper
direction. Check plug, cord and switch for damage. Thermal protection switch may have
tripped, the motor can restart after cooling.
