6
5. Remove the two screws and the plastic retainer clip that holds the cord in place.
6. Unscrew the clear plastic UV lamp connector nut and carefully remove from housing.
7. Carefully set the UV assembly aside being careful not to touch the UV lamp. If you are
replacing the UV lamp, follow the instructions above.
8. Gently pull straight up on the treaded connection in the middle and remove the UV housing.
9. Be sure to use caution as the quartz sleeve is glass and can break. If the sleeve is broken use
proper protection for your hands and eyes while cleaning glass from the filter.
10. To remove the sleeve from the UV housing, unscrew the top
fitting. The glass section is secured to the top section and the
whole piece will be replaced.
11. Thread the new quartz sleeve assembly onto the UV housing.
12. Reuse the black end piece from the old sleeve and place on the
new sleeve.
13. Carefully replace the UV housing into the filter. Be sure it is
seated properly.
14. Replace the UV lamp assembly and screw it back in place being
careful not to touch the UV lamp.
15. Reattach the cord retainer clip with the two screws.
16. Line up the cord properly in the housing and replace the top cover and circular retaining
ring. Secure with the six screws.
17. Return the unit back to service.
Filter Specifications
EC1300
EC1300U
Maximum Pond Size with Fish* (gallons)
650
650
Maximum Pond Size without Fish* (gallons)
1300
1300
UV/Watts
n/a
9 Watts
Inlet/Outlet Sizes
1
/
2
",
3
/
4
", 1"
1
/
2
",
3
/
4
", 1"
Recommended maximum GPH
1300
1300
Volts / Frequency
n/a
115 V / 60 Hz
Cord Length
n/a
16 feet
*Fish load, amount of sunlight, etc. all affect actual maximum gallons filtered.
Step 10
15.47"
14.80"
12.24"
