4. Use with or without removable base to fit fixture into desired location. If
base is used it may need to be ballasted to prevent fixture from shifting.
5. Run wire from LED fixture back towards control module and power source.
6. Join the light to the control module by connecting
the 4-prong Quick Connect, tighten the retention
ring to ensure a secure connection. (Figure 1) Do not
submerge connection or control module.
7. Join the control module to the transformer by con-
necting the 2-prong Quick Connect and tighten the
retention ring. (Figure 2)
Note: Power supply must be maintained to con-
trol module or light will default back to mode 1 on
startup (transformers with automatic operation will
reset the control module back to default on each
start due to power interruption.)
8. Plug the transformer into a GFCI outlet.
9. The LED light will default to mode 1 on initial startup. Use CLEDRC remote
to sync multiple Cabrio fixtures together, change modes, brightness and
speed.
Power on/off
Slower Speed
Lower Brightness
Change Mode Backwards
Red (mode 21)
Blue (mode 23)
Reset Defaults (mode 1)
Faster Speed
Raise Brightness
Change Mode Forwards
Green (mode 22)
White (mode 27)
Remote Control Operation
(remote control sold separately)
• A single remote can operate multiple Cabrio fixtures in any combination
within its range.
• Depress mode, brightness and speed buttons slowly and deliberately to
ensure all light fixtures remain in sync on the same cycle.
• Desired setting must be achieved by clicking remote functions, holding a
button down will not change settings.
• CLEDRC remote requires an A23 battery (included).
Installation of LED Light
(continued)
A23 battery included
Figure 1
Figure 2
