3
Safety Information
It is important that this machine is installed, maintained and used correctly to avoid
It is important that this machine is installed, maintained and used correctly to avoid
It is important that this machine is installed, maintained and used correctly to avoid
It is important that this machine is installed, maintained and used correctly to avoid
the risk of injury.
the risk of injury.
the risk of injury.
the risk of injury.
This machine contains dangerous voltages and rotating mechanical parts.
This machine contains dangerous voltages and rotating mechanical parts.
This machine contains dangerous voltages and rotating mechanical parts.
This machine contains dangerous voltages and rotating mechanical parts.
•
Use the machine only for the purposes described in the Operating Manual.
•
This machine is to be used only by trained personnel.
•
Do not operate without the guards properly in place.
•
The machine is to be serviced or repaired only by suitably trained or qualified
personnel.
For safety always switch off the machine from the mains supply before freeing card
For safety always switch off the machine from the mains supply before freeing card
For safety always switch off the machine from the mains supply before freeing card
For safety always switch off the machine from the mains supply before freeing card
jams or removing any covers.
jams or removing any covers.
jams or removing any covers.
jams or removing any covers.
The machine can be stopped in an emergency
The machine can be stopped in an emergency
The machine can be stopped in an emergency
The machine can be stopped in an emergency by pressing down the red mushroom
button (with a yellow disc below) located on the top of the machine.
The machine can be stopped at any time by pressing the red (0) switch.
A red neon indicator on the control panel is illuminated to warn when electrical
power is connected.
It is recommended that metal staples are removed prior to shredding,
It is recommended that metal staples are removed prior to shredding,
It is recommended that metal staples are removed prior to shredding,
It is recommended that metal staples are removed prior to shredding, as staples cut
during the shredding process will leave sharp pieces in the shredded material, which
could cause injury during handling.
•
The machine uses a 230V (±10%), 50Hz, single-phase AC supply.
•
To protect against electric shock, do not immerse the plug or mains cable in
water or spray with liquids.
•
Do not operate this machine with a damaged mains cable or plug.
•
To disconnect from the electrical supply, grip the plug - do not pull on the
mains cable.
THIS MACHINE MUST BE EARTHED
THIS MACHINE MUST BE EARTHED
THIS MACHINE MUST BE EARTHED
THIS MACHINE MUST BE EARTHED
The wires in the mains cable are coloured to the European standard
Green
/
Yellow
Earth
Blue
Neutral
Brown
Live
