11
2. Installation and Configuration
2.4 Resetting to the Factory Default Settings
To reset the Network Camera to the original factory settings, use the Reset button on the
network camera, as described below:
Using the Reset Button
Follow the instructions below to reset the HD Camera to the factory default settings using the
Reset button.
1. Power off the HD Camera by disconnecting the power adapter or Cat5e/Cat6 network
cable if it is connected to Power over Ethernet.
2. Remove the rear cap of the camera.
3. Press and hold the Reset button with a straightened paperclip while reconnecting the
power.
4. Keep the Reset button pressed during about 2 seconds.
5. Release the Reset button.
6. The HD Camera resets to factory defaults and restarts after completing the factory
reset.
7. Close the rear cap of the camera.
CAUTION: When performing a Factory Reset, you will lose any settings you have saved.
Please consult with NUVICO Technical Support first before doing so since this can
interrupt the communication to the recorder.
