Easylife EL5868, Instruction Manual

Page: 3 / 5

PANTONE 072 C
PANTONE 123 C
Customer service: 0871 855 6100
For more innovative products from Easylife please visit:
www.easylifegroup.com
Dear Customer
Thank you for purchasing the Solar PIR Security Light.
IMPORTANT SAFETY INSTRUCTIONS
• Do not install close to where other people or passing vehicles could tamper or obstruct the security
light. Keep children and infants away from the product.
• Do not install close to anything flammable.
• Install the security light on a solid and vertical base.
• The solar panel should face towards the sun in order for it to re-charge. Clean the panel
before charging.
• Do not stare directly at the light for a long time while it is on.
• Do not install it close to other products that send radio waves.
• To prevent it from falling, install the base unit correctly with an expansion screw.
• The security light cannot prevent crimes by itself. It’s use is only intended as a deterrent and should be
used in conjunction with other home security systems.
• Make sure the solar panel jack is fully inserted into the socket of the light head fixture.
CHARGING THE BATTERY
• You can charge the battery using solar panel.
• Position the switch to “AUTO” or “OFF” when you install the solar panel.
• The solar panel should face towards the sun. If the solar panel is dirty it will hinder and prevent the
battery from charging efficiently.
PART LIST
Part Description Part Description
1 Lamp 8 ON/OFF/AUTO Switch
2 Solar Panel (5m wire) 9 Battery Housing outlet
3 Expansion screw 10 Solar Panel Mounting Bracket
4 60PCS LED 11 LUX Adjusting Knob
5 Battery Housing 12 SENS Adjusting Knob
6 Motion Detector Head 13 TIME Adjusting Knob
7 “U” shaped Mounting Plate 14 NI-HM battery (not shown)
PARTS
INSTALLATION
• The security light should be set up in a location where you require additional lighting in order to detect
persons or objects that move at night or in the dark.
• Decide where you want to place the lamp (1) and solar panel (2).The Light is equipped with 5 metres
of connecting wire so the Lamp (1) and Solar panel (2) can be installed up to 5 metres apart.
• The Solar panel (2) must be set in a location that receives full, direct sunlight with a minimum of 8
hours a day. So we advise putting it on a wall or roof.
• Mount the lamp (1) 2 to 3 metres above ground on a solid surface capable of supporting the lamp (1)
and secure enough so that it will not move when exposed to vibration or wind. The unit must be high
enough to allow for the motion detection and light distribution.
• Using the mounting plate as a template mark where lamp is to be installed. Secure in place the
mounting plate with the mounting screws (3) provided.
• Install the solar panel (2) in the same way that you installed the lamp (1).
• Carefully route the power cord of the solar panel (2) to the lamp (1) and plug it into the battery
housing outlet (9).
• Adjust the motion detector head (6) below the light by moving it left or right so that it faces the area
where movement will occur. Move it up or down by using the screw located on the neck of motion
detector head (6).
Paper weight 60gsm