SETTING
THE LIMITS
Now if you put your gates in the close position by releasing them, manually moving them closed and
locking them back in, we can set the limits.
For single gates-
Press the learn limit button once. ‘Set open limit’ LED should be flashing. Hold down the right ‘Gate
one’ button until you reach the fully open position you want for your gate. (if you hold this button
down and it doesn’t do anything or tries to close press the button opposite to open the gates). When
the gate is fully opened to your desired range, press the ‘Learn limits’ button once more.
‘Set close limit’ should be flashing. Use the opposite button that you used for opening and hold down
until the gate is closed. Then finally press the ‘Learn limits’ button again. You should now be ready to
operate your gates. You can test this by pressing ‘Single button’.
For Double gates-
Press the learn limit button once. ‘Set open
limit’ LED should be flashing. Hold down
the right ‘Gate one’ button until you reach
the fully open position you want for your
gate. When gate one is open, hold down the
open button for ‘Gate 2’, directly under-
neath it, until it is open. When the gates are
fully opened to your desired range, press the
‘Learn limits’ button once more.
‘Set close limit’ should be flashing. Use the
opposite buttons that you used for opening
and hold down until the gates are closed.
Then finally press the ‘Learn limits’ button
again. You should now be ready to operate
your gates. You can test this by pressing
‘Single button’.
Disclaimer:
Please note this is just a guide and may vary
according to your setup. Please read all
instructions from the manufacturers before
refering to our guides. Easygates Ltd will not
be held responsible for any damage due to
equipment caused due to poor wiring.
