EZDIVE
EZDIVE
EZDIVE
EZDIVE Jaeger
Jaeger
Jaeger
Jaeger 600/1000
600/1000
600/1000
600/1000 USER
USER
USER
USER GUIDE
GUIDE
GUIDE
GUIDE
4
Pre-Dive
To ensure years of dependable service
from your light, follow the steps below
during your pre-dive setup.
Is your battery charged?
Be certain that the sealing o-ring is in
place. There is really no reason to remove
this o-ring during storage.
Periodically you should inspect the
o-ring and wipe dry any excess grease
and sand, do not lubricate as it will
attract dirt and grit.
Turn the casing clock-wise until it is tight
Make sure not to over tighten the casing
as this could result in pre-mature wear
and/or damage to the O-rings. Do not
use tools to tighten the case.
Turn on the light and make sure it comes
on.
Turn off the light and finish preparing for
your dive.
To ensure years of dependable service
from your light, follow the steps below
during your post--dive breakdown.
Always rinse your gear after a salt-water
dive
Before opening the light, make sure you
dry any excess water
Check for any water in the case.If there
was any water intrusion, it is best to
