• Insert the adjustable frame into the window reveal as shown in figure
3(A).
• Using the Allen key, adjust the frame evenly by turning each adjuster 2 full turns at a time in an
anticlockwise direction to expand frame into the opening. Adjust each side adjuster evenly until a
tight, square fit, is achieved as shown in figure
3(B)
• Using the screws provided, secure the frame in place by inserting one screw into each side of the
frame. Each screw should be inserted through the hole in the centre of each adjuster, as shown in
figure
3(C)
• Insert the shutter panel onto the hinges and secure with the hinge pins, as shown in
figure
4 (A)
• Open and close the shutter panel to check fit as shown in figure
4(B)
• Using the Allen key, make small adjustments to the adjustable frame, to align the door if required
NOTE:
At this stage only use 1 screw on each side & insert
through the adjusters closest to the centre of each side.
NOTE:
Hinges must be facing toward you when mounting.
3(B)
3(A)
3(C)
USE ALLEN KEY
Frame Screw
70mm
NOTE:
Take care while placing hinge pins to avoid damage and
scratches.
4(B)
4(A)
Hinge Pin
NOTE:
Open and close the shutter panel
STEP 4
STEP 3
