7
C5
Factory reset
Performing a factory reset restores all settings of
all
outputs to the factory default.
All programmed transmitters and, if applicable,
also the server are deleted and all switching times
set back to the default value.
The external button inputs are assigned to the
original output again:
EXT1 button: Output 1 (CH1) -> 1TB, ON/OFF
EXT2 button: Output 2 (CH2) -> 1TB, ON/OFF
Operation
[Press button]
Indication
Note
1.
M
keep
pressed
2.
CH1
+
CH2
keep
pressed for
5 s
Symbol
is displayed for 4 s.
Factory reset has been carried out, all set-
tings have been reset. When the display is
off, the receiver is ready for operation.
C Programming
D
Bidirectional functions (Easywave neo)
To enable the use of bidirectional functionalities,
an APC01 Easywave neo server can be pro-
grammed to the RCU08.
The RCU08 is automatically recognised and con-
figured by the server as a 2-fold switch receiver.
During programming, the server automatically
recognises the number of available channels and
does not have to be separately programmed into
each channel.
The available range of functions is also recog-
nised automatically, so that no specific operating
mode has to be selected when programming in
a server.
Program the APC01 server according to the in-
structions in the Easywave app.
After programming, the server receives feedback
of every switching operation carried out, even if
the operation is triggered by another transmitter/
button or manually by the CH1 and CH2 buttons
on the RCU08.
This means that the current status of each output
can be shown via the relevant app at any time.
An incoming switch command via the server is
shown as a dash (-) on the display of the RCU08.
D1
Programming a server
Only one server at a time can be programmed into
the receiver. A server that has already been pro-
grammed will be overwritten.
D2
Deleting a server
To delete a server, the receiver must be supplied
with power.
Alternatively, for deletion via the app, the server
can also be deleted by performing a factory reset
on the receiver.
Operation
[Press button]
Indication
Note
1. Delete the receiver in the app while the receiver is supplied with power
and is within range of the server.
Operation
[Press button]
Indication
Note
1. Start the prorgramming process in the ap. As soon as you are prompted in the app,
start the programming mode on the receiver (see point 2.).
2.
P
press 1x
briefly
The display shows
the last operating
mode selected.
All operating modes possible except
(delete mode).
If the display shows , press
the
M
button 1x briefly to exit the delete
mode.
3.
Complete the programming process via the app.