REMOTE KEY FOB REPROGRAMMING INSTRUCTIONS
ALL EG4MDC2-F ATTACHMENTS ARE PROVIDED WITH FOUR KEY FOBS
To Begin:
With the attachment attached to the lift truck, elevate the attachment so the bottom of
the magnets are at eye level. This makes the programming process more ergonomic for the
operator rather than attempting to access the bottom of the magnets from floor level.
To Access the wireless teaching button:
On the bottom side of every magnet there is an access
hole and two small LED lights, one blue and one green. These small lights are helpful when
reprogramming the key fobs. Use a 3mm Allen key to unthread the M5 cap screw on the bottom
of each magnet.
To Pair a Remote with a Magnet:
With the screw removed, inset the 3mm Allen key into the
hole where the screw was removed until it touches the teach button inside the hole. Hold the
button in for 2 seconds to put the receiver in pairing mode. Within a few seconds of releasing
the teach button, push the key fob button “ON”
.
Then wait a few seconds for the key fob and
magnet receiver to pair. Then, test the pairing by pushing the key fob button “ON”
again. The
green light on the magnet, the battery cabinet lid and underside of the attachment will illuminate.
Repeat this procedure until all four magnets have been paired with the same key fob.
Test the system by turning on and off all four magnets/green lights consistently.
If all four lights do not illuminate, continue to press the key fob button “ON” until all four lights
are illuminated. If one or more magnets do not pair, repeat the pairing process with the magnet
having the problem until all four magnets/green lights consistently turn on and off.
Re-closing the Magnet:
When all programming is complete, insert all the M5 cap screw back
into the bottom screw hole of each magnet and tighten until snug.
NOTE: All Eagle-Grip® Attachments conform to OSHA standards. A metal plate, affixed
to each attachment, provides model number, serial number, rated capacity and attachment
weight. OSHA requires contacting the lift truck manufacturer for written approval of any
attachment to be used on a lift truck. Should the metal plate be missing - call for a free
replacement
7
