Easy-Laser E540, Manual, Page: 42 / 84

38
Horizontal
Live values
When reading the values, face the stationary machine from the movable machine.
Positions for measuring units as seen from the movable machine.
Live values are marked with yellow frame.
Face the stationary machine (S) from the movable machine (M). Then 9 o’clock is to the left, as in the measuring programs.
12
3 9
6
Offset and angle values
The offset and angle value indicate how well the machine is aligned at the coupling.
They appear in both horizontal and vertical direction.
These values are important to get within tolerance.
Offset
The centre lines of two axis are not concentric but parallel.
This is measured at the coupling centres.
In this example, a positive offset is shown.
Angular misalignment
The centre lines of two axis are not parallel.
In this example, a negative angle is shown.
Offset and angular misalignment
Misalignment is often a combination of both offset and angular
misalignment.
Show live values for EasyTurn
TM
The inclinometer can be used to show live values at all angles.
Show live values at any angle.
Inclinometer controls when to show live values.
Show live values for 9-12-3
The inclinometer is not used. You can manually show in which position your measure-
ment units are.
Select
to show the live options.
Force live to 6 o’clock.
Force live to 12 o’clock.
Force live to 3 o’clock.
Force live to 9 o’clock.
www. .com
information@itm.com 1.800.561.8187