SteP 1: Platform to Back leg frame
fit 4 x m10 x 20mm bolts into holes at the non-ladder end, on both sides of the
platform. finger tighten with the nyloc nuts to the inside of the platform.
(1)
SteP 2: Platform/ladder Back leg frame
lay the platform frame top down on a flat surface with the ladder frame facing up.
note: the ladder may need temporary support on larger models.
SteP 3 Platform to Back leg frame
attach the back leg frame to the ladder/platform frame by sliding the bolt heads into the slots in the frame
extrusion.
(3)
bring the two components together and firmly tighten the nyloc nuts
(4)
the ends of the two
pieces of extrusion must be firmly touching each other with no gap. note: a soft headed mallet may be used
carefully to help position the ends.
(5) The angle between the back leg frame and the ladder platform
must be 90º.
note: if side outriggers are to be fitted to the platform then insert 4 m10 x 20 standard bolts into
the extrusion slots on both sides of the back leg frame before attaching the frame to the platform.
tools required
•
carpenters square
•
Socket wrench or impact driver
and 17mm socket
•
Soft-headed mallet
•
17mm ring spanner
•
allen key 6mm
ComPonentS
aSSemBly InStruCtIonS
Hardware
Wheel Assembly x 2
Side Braces x 2
(4x for WHDP09 and larger platforms)
Ladder Handrail x 2
Back Leg Frame
Ladder/Platform
Frame
M10x20mm Bolt
M8 Nyloc Nut
M10 Nyloc Nut
M10 T-Bolt
M8x40mm Button-
Head Bolt
M8x55mm Bolt
1.
3.
5.
4.
2.
Lift up Entry Gate
and Hardware
Corner Brace x 2
(WHDP06 - WHDP11)
Bolts
Side Handrails and Exit Gate
M8x35 Button
Head bolt
Note: exit gates
on models up to
WHDP06 don’t
have a toe board.
