The
Eastwood MIG Stud Welding Kit
transforms your MIG welder into a Stud Welder which can be
used to repair and remove dents from sheet metal.
WARNINGS
• DO NOT insert pins with bare hands as the nozzle will get very hot and will cause a burn.
• Follow all safety precautions in your Welder’s Instruction Manual.
• Wear appropriate safety equipment: Welding Helmet (Min Shade #11), Gloves, Long Sleeve
Shirt and Pants, etc.
• Do not touch pin, nozzle, or welding wire while in use.
• Do not use on, near, or around fuel tanks.
• Be aware of your surroundings.
• Notify anyone in your area before using.
SPECIFICATIONS
The following items are included with your Eastwood MIG Stud Welding Kit:
• Stud Welding Nozzle
• Slide
Hammer
• 100 2mm Pins
• Replacement Slide Hammer Knurled Locking Cam
SET UP
To utilize your Eastwood MIG Stud Welder Kit, you will need a MIG welder with a minimum of 100 Amp
output that utilizes a Tweco style nozzle
NOTE:
This was designed for Tweco Style torches but may work on other styles.
NOTE:
All of the following steps MUST be completed with the welder turned off and unplugged.
1.
Loosen the set screws on the body of the Stud Nozzle and slide it over your gas nozzle.
2.
Tighten the set screws once the Stud Nozzle has been put in place but keep in mind that it may
need to be adjusted when getting started for optimum results.
3mm Set Screw
Tweco
Style
Torch
