6
Eastwood Technical Assistance: 800.544.5118 >> [email protected]
1.
When mounting the unit, the Spacer Plate
(t)
must be located between the
Lower Frame Plate
(a)
and mounting surface. This is necessary to allow full
Drive Pin projection through Plates
(Fig 8)
.
2. Check for alignment:
Temporarily Insert the Ø 7/8" x 6-3/4" [Ø 22mm x
172mm] polished Drive Pin
(L)
through the Ø 22.5 holes in both Frame
Plates to align them. Tighten both M12 bolts & nuts then remove the
Drive Pin
(Fig 8)
.
3.
The optional Bender Handle (#21129) may be installed over the Ratchet Lever
(p)
at this time
(Fig 9)
.
attaCH dEgrEE pLatE
1.
Locate the Degree Plate
(u)
under the Lower Frame Plate, align the 2 holes in
the Degree Plate with those in the Lower Frame Plate and fasten with two M8
Bolts
(V) (Fig 10)
.
FIG. 8
FIG. 9
usagE HaZard!
sudden slippage of the bender Handle during use can cause
serious injuries. be sure the clamping bolts are securely
tightened before use.
FIG. 10
✓
b
✓
✓
✓
✓
L
a
t
#21116
stand
✓
u
✓
V
✓
