To order parts and supplies: 800.345.1178 >> eastwood.com
5
FOR BEARING/HOUSING SEPARATING
• Select the needed Bearing Separator Jaw size
(C OR D)
as required
(FIG 2)
.
• Place the halves of the Jaws
(C OR D)
with the beveled edges around the halves of the bearing
and housing to be separated.
• Draw the halves inward by tightening the nuts on the Jaw Stems.
BEARING/GEAR PULLER OPERATION
FOR BEARING/GEAR PULLING
• Be sure the nuts keeping tension on the Jaw
(C OR D)
halves are kept tight and the two halves
of the Jaw are drawn in evenly.
• Rotate the Hex on the end of the Pressure Screw
(B)
slowly and steadily exerting pressure until
the bearing or gear is released from its shaft.
FOR BEARING SEPARATING
• Apply a small amount of a heavy-bodied lubricant on the beveled edges of the Jaws
(C OR D)
.
• Draw the Jaw halves inward by tightening the nuts on the Jaw Stems equally. It is best to
alternate tightening each side with one turn each steadily exerting pressure until the bearing
and housing separates.
C or D
FIG. 2
✓
