6
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
• To begin grinding, allow several sec-
onds for the motor to reach full speed,
then gently place the tungsten into the
proper width slot
(FIG 4)
.
• Slowly and steadily allow the tungsten
to contact the face of the Diamond
Grinding Wheel while rolling the
tungsten to create a sharpened tip. DO
NOT force the tungsten but allow the
abrasive of the Diamond Grinding Wheel
to do the work.
• When the grinding is complete, with-
draw the tungsten and move the On-Off
Switch to the “OFF” position.
BREAKING OFF BURNED
TIPS ON TUNGSTEN
• Place the burned end of the tungsten
into the proper width slot and quickly
move the tungsten to the side to snap it
off
(FIG 5)
.
FLIPPING AND
REPLACING DIAMOND
GRINDING WHEEL
• Using a 3mm Hex Key (not included),
loosen the four Retaining Set-Screws
(FIG 6)
.
• Remove the Grinding Head and set it
aside
(FIG 7)
.
FIG. 4
FIG. 4
FIG. 5
FIG. 5
FIG. 6
FIG. 6
FIG. 7
FIG. 7
