RECHARGEABLE
COB LED PALM LIGHT
INSTRUCTIONS
© Copyright 2020 Eastwood Automotive Group LLC 11/20 Instruction item #33935Q Rev 1
If you have any questions about the use of this product, please contact
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: [email protected]
PDF version of this manual is available at eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA 800.343.9353 eastwood.com
Item #33935
OPERATION
• Fully charge the Light before use.
• Grip the lamp housing and rotate Magnetic
Base through 180°
(FIG 1)
.
• Place the base against any ferrous metal
surface for magnetic attachment.
• Release Retractable Swivel Hook to hang from
overhead objects.
• Depress and release round Button located at front of Housing once for High-Intensity
COB LED Illumination, 2nd time for
Low-Intensity COB LED Illumination and a 3rd time for the Flashlight
(FIG 1)
.
• Depress Button once again to turn off.
CHARGING
• When the Indicator light above the Charging
Port illuminates RED, the battery requires a
charge. To do so:
- Flip up rubber seal and plug the Micro-
USB terminal of the included Power Cord
into the Micro-USB port on the side of the housing
(FIG 2)
.
- Plug the USB terminal of the Power Cord into the USB output port of the included 120VAC
to 5V 1A Charger.
- Plug wall unit into properly grounded 120 VAC, 60 Hz. outlet.
- Allow 2.5 hours for full charge.
- Do not use Light while charging.
- The Indicator Light above the Charging Port will flash RED while charging then change to
GREEN indicating full charge
(FIG 2)
.
- Close Charging Port Cover to maintain IP-20 rating.
- Do not leave Light on charge beyond 24 hours.
Batteries will automatically discharge without use and must be charged every
3 months even if the light has not been used.
Do Not charge batteries in temperatures below 40°F [4.4°C].
FIG. 1
FIG. 2
