To order parts and supplies: 800.343.9353 >> eastwood.com
7
FIG. 5
CHIP DISPERSAL BLOWER (FIGS 5 & 6)
Located at the lower right, forward side of the
saw housing.
Controls the dispersal of chips from the
cutting area. When on, it allows air from the
motor cooling fan to blow chips out and away
from the cutting area providing a clear view
of the blade and cutting path.
This is a 2-position switch When the Lever
is placed in the full “Down” Position, the
Dispersal Blower is On, when it is rotated
45 up, it is off.
ADJUSTMENT
BASE ANGLE (FIGS 7 & 8)
Located at the Saw Base.
Using the supplied 4mm Hex Key, loosen
the set-screw in the retaining plate at the
underside of the Base, rotate the Saw Base
to the desired position using the built-in angle
detents then tighten set screw to lock it in
place.
GUIDE FENCE DEPTH (FIG 9)
Located at the front of the Saw Base.
Using the supplied 4mm Hex Key, loosen the
set-screws in the forks of the Saw Base, slide
the Fence (marked in 0.5 Centimeter gradua-
tions) to the desired position then tighten set
screws to lock it in place.
FIG. 7
FIG. 8
FIG. 6
FIG. 9
Dispersal OFF
Dispersal ON
