4
Eastwood Technical Assistance: 800.544.5118 >> [email protected]
SET-UP & CONNECTION
1.
Be sure that the air supply to the tool is clean and dry. Moisture in the supply line will quickly
damage the motor and valves.
2.
A minimum 3/8” I.D. air line should be used for optimal performance.
3.
Thread the included 1/4" Male Quick-Disconnect Fitting into the tool using TFE thread sealing
tape (not included).
OPERATION
• Rotate the lever located at the left rear of the tool handle to regulate motor speed
(FIG 1)
.
Note that the “down” position will result in slower speed while “up” will increase speed.
• Depress Throttle Paddle inward with fingers to operate tool..
• Keep the broad work surface of the Abrasive Belt parallel to the work surface whenever
possible to minimize uneven wear and maximize usable life.
• Always maintain a firm grip while operating tool, do not force but allow the rotational speed
of the Abrasive Belt to do the work.
• Be sure that the workpiece is clamped down or held securely to minimize the danger of
injury while operating tool.
FIG. 1
