4
Eastwood Technical Assistance: 800.544.5118 >> [email protected]
ASSEMBLY
APPLY SEALING FOAM (FIG 1)
Peel away protective paper and apply Sealing Foam
(MM)
on
the outer, short-side fl anged surfaces of the Front Panel
(D)
,
and along the outer short-side end fl ange surfaces of the
2 Side Panels
(C+E)
.
ASSEMBLE CABINET PANELS (B), (C), (D) & (E) (FIG 2)
Trapping the Sealing foam between panels, assemble the
Rear Panel
(B)
with baffl e at the upper left to the 2 Side Panels
(C+E)
and to the Front Panel
(D)
with fl anges all facing inward
then attach with
(12) M6 x 12 screws
(AA)
and M6 nuts
(EE)
.
Do not fully tighten hardware at this point
INSTALL CORNER REINFORCEMENTS (N) (FIG 3)
• Peel away protective paper and apply Sealing Foam
(MM)
to
the upper surfaces of the (4) Corner Braces
(N)
.
• Install (4) Corner Braces
(N)
to the upper underside corners of
the Cabinet Assembly with (8) M4 x 10mm screws
(CC)
and
nuts
(FF)
trapping the Sealing Foam between Corner Braces
and panel fl anges. (Fully tighten all screws
at this time).
• It is recommended to put a dab of silicone or RTV in the corners
of joints to prevent air or media leaks.
FIG. 1
FIG. 1
FIG. 2
FIG. 2
FIG. 3
FIG. 3
4 Pcs.
MM Sealing Foam, 3mm
4 Pcs.
MM Sealing Foam, 3mm
8 Pcs.
CC
M4 x 10mm Screw
MM
MM
MM
D
C
E
D
C
E
B
N
12 Pcs. AA
M6 x 12mm Screw
12 Pcs. EE
M6 Nut
MM
Dab of Silicone
or RTV
Dab of Silicone
or RTV
