6
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
REMOVING & REPLACING DIE FINGERS
The individual Die Fingers located in the Male Die may be removed and rearranged for greater
precision in bending workpieces or may be replaced if nicks or damage should occur.
•
To Remove
Using a 5mm Hex Key (not included), loosen the socket head cap screws and remove the
desired Die Fingers
(FIG 3)
.
•
To Replace
Insert Die Fingers into the Male Die as required, use care to properly align the sharp bending
edges then, once again, using a 5mm Hex Key, tighten all screws.
FIG. 3
