4
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
FIG. 1
SET-UP
• Select a clean, level work surface with sufficient room to
manipulate workpieces through the Shrinker Stretcher.
ASSEMBLY
POST ASSEMBLY [B] TO BASE [A].
• Place Base
[A]
on a clean, level floor
(FIG 1)
.
• Set the flange of the Post Assembly
[B]
on the Base
[A]
and align
the four mounting holes with the threaded holes of the Base
(FIG 2)
.
• Thread four M10 x 15mm Socket Cap Screws through the holes in
the flange and into the Base
(FIG 3)
and tighten securely with an
8mm Hex Key (not included).
PEDAL ASSEMBLY [C] TO POST ASSEMBLY [B].
• With the Pedal facing upward, insert pivot of Pedal Assembly
[C]
through front opening of triangular section of Post Assembly
[B]
(FIG 3)
.
NOTE:
The threaded Drive Stub attached to the Pedal Assembly
must be kept in the UP position and visible through the slot of the
triangular section of the Post Assembly
• Align the threaded pivot of Foot Pedal
[C]
with holes in the sides of
the Post Assembly triangular section
[B]
.
• Thread two M10 x 20mm Socket Cap Screws through the side holes
in Post Assembly and into the threaded Foot Pedal pivot
(FIG 4)
and
tighten securely with an 8mm Hex Key (not included).
FIG. 2
FIG. 3
B
✓
FIG. 4
A
✓
