2
Eastwood Technical Assistance: 800.544.5118 >> [email protected]
To order parts and supplies: 800.345.1178 >> eastwood.com
7
READ INSTRUCTIONS!
Thoroughly read and understand this instruction manual before using. Save manual for future reference.
SAFETY INFORMATION
ELECTRIC SHOCK HAZARD!
• Never operate or store unit in damp or wet conditions.
• If an extension cord is required, a 25' cord is recommended not to exceed 50'. All extension cords must be 14 AWG or greater.
• Always unplug Turbine Unit before refi lling gun cup, cleaning or servicing the Paint Gun’
HEALTH HAZARD!
• Avoid breathing vapors produced by Spray Gun. Always wear appropriate NIOSH approved breathing apparatus and use in a well
ventilated area.
• Wear appropriate eye protection.
• Wear solvent-resistant gloves.
• This device emits high sound levels, the use of appropriate hearing protection is strongly recommended. Never operate the Turbine
Unit without Paint Gun attached to hose.
FIRE AND EXPLOSION HAZARD!
• DO NOT allow fl ammable paint spray or vapors to enter the air intake of the Turbine Unit! Keep the Turbine Unit away from the painting
area and in an elevated, secure position at all times.
• Never use a coating or solvent with a fl ash point lower than 70°F (21°C). If unsure, refer to the MSDS for the particular products in question.
• Do Not use near sparks, open fl ame or other potential ignition source.
REASSEMBLY FOR REBUILD/REPAIR
1. Insert the Fan Adjustment Seal
(Fig Q)
.
2. Insert the Fan Adjustment Ring and Air Distributor Plate
(Fig P)
.
NOTE:
If you have
separated these two pieces it is critical that the white Air Distributor Plate is correctly
re-inserted into the Fan Adjustment Ring. Note that the open slots on the Air Distributor
Plate must be visible through the holes of the Fan Adjustment Ring. Using the back end of
the Needle assembly, move the Distributor Plate so that the round screw hole is at the
5 o’clock position. DO NOT put the Distributor Plate and Fan Adjustment Ring together at
this point.
3. Place the Air Distributor on top of the paired Fan Adjustment Ring and Air Distributor
plate. Align the screw hole in the Air Distributor with the holes in the Fan Adjustment Ring
and Air Distributor Plate
(Figs R1 & R2)
.
4. Place Air Cap Assembly over Stainless Steel Locating Pin
(Figs S & T)
.
5. Screw the Fluid Nozzle back onto the Spray Gun body, fi nger tight. Rotate the Fan
Adjustment Ring to be sure it rotates freely and easily. Tighten the Nozzle slightly more
with the wrench (included). Rotate Fan Adjustment Ring again. Do not over tighten the
Fluid Nozzle as it will stop the Fan Adjustment Ring from rotating. If too tight, back off
slightly. Be sure that the Fluid Nozzle is not too loose or leaking will occur.
6. Insert the Air Cap Seal
(Fig U)
. To insert, observe both sides of the seal. One side should
have three small circles. This side goes toward the Spray Gun. Snap the Air Cap Seal onto
the Air Distributor.
7. Push the needle back into the spray gun.
– Insert the Needle spring into the Material Adjustment Screw
(Fig V)
.
– Install the Material Adjustment Screw with Needle Spring.
– Install air cap and air cap ring. Spray gun is now re-assembled and ready to use.
FIG. O
FIG. P
FIG. Q
FIG. R1
FIG. S
FIG. T
FIG. R2
FIG. U
FIG. V
Fan Adjustment Seal
Correct
Incorrect
Air Cap Seal
Stainless
Steel
Locating Pin
Counterbored
Hole
