2
Eastwood Technical Assistance: 800.544.5118 >> [email protected]
WARNINGS
•
This tool has high-speed, highly abrasive surfaces which can quickly cause severe injury.
Keep fi ngers and hands away from moving parts
when operating.
• Wear thick, well-fi tting work gloves, and keep loose clothing, sleeves, cords, jewelry and hair away from moving parts.
• Wear appropriate eye protection. Metal particles and dust can be ejected during the grinding/sanding process.
•
Wear appropriate respiratory protection. Hazardous dust is generated during the grinding/sanding process.
•
Frequently inspect belt and disc condition. If tears or holes develop, discontinue tool use immediately and replace damaged disc or belt.
INCLUDES
• (1) Disc/Belt Assembly
•
(1) Belt Sander Tool Rest/Stop Fence with Screws & Washers
• (1) Disc Sander Adjustable Work Surface/Miter Plate and Lock-Down Knob
•
(1) Disc Sander Miter Gauge and Fence
• (1) 6mm Hex Key
SPECIFICATIONS
• 120 VAC/60Hz, 4.3 Amps
• 1/2 HP, 3420 RPM
• Belt : 4” x 36”, 80-grit
•
Disc: 6” pressure-sensitive adhesive-backed, 80-grit
ASSEMBLY
•
Attach the Stop Fence/Tool Rest to the Belt Sander assembly with the two 6mm socket
head cap screws and washers included. Keep the bottom edge of the Fence/Rest ap-
prox. 0.063” [1.5mm] from the belt and tighten screws securely.
NOTE:
Fence/Rest should not contact sanding belt. Check for contact with belt and
re-adjust if necessary (Fig. 1).
• Attach the Adjustable Work Surface/Miter Plate to the cast housing by placing the locat-
ing pin into the hole and securing with the yellow Lock-Down Knob.
NOTE:
Work Surface/Miter Plate should not contact sanding disc. Check for contact
with disc and re-adjust if necessary (Fig. 2).
SET-UP
•
Using suitable lag bolts or through bolts and nuts (not included), securely bolt the hous-
ing fl anges to a secure work surface to prevent tool movement while
in use.
•
The Belt Sander feature position is adjustable from horizontal to 90° vertical.
To adjust: Loosen 6mm socket head cap screw on Belt Sander Pivot Clamp
with 6mm wrench included, choose your preferred working position for the
Belt Sander, then tighten screw securely to lock it in position (Fig. 3).
NOTE:
Be certain the Belt Sander Assembly is securely clamped. Severe
personal injury could occur if Belt Sander Assembly position slips during use.
The
EASTWOOD 36” BELT & 6” DISC SANDER
is designed for rugged reliability and ease of use. The positionable belt drive assembly provides a full 90° of adjustment from
horizontal to vertical, and features a secure stop fence/tool rest for safety and convenience. The 6” disc sander features an angle-adjustable
work surface and sliding miter gauge/fence to allow grinding to precise angles with one convenient bench-mount tool.
FIG. 1
FIG. 1
FIG. 3
FIG. 3
FIG. 2
FIG. 2
