Eastsign
R
O
TAR
Y
HE
AT
PRE
SS
MO
T-
M
USER
MANU
AL
16
7. Operation Guide
7.1.
Before switching on the machine, make sure that all electrical wires are connected correctly. The body of
the machine must be connected to ground. Press the power switch and belt start rotary switch. Then,
adjust the rotary speed on speed adjustor (6) to optimum value. When the heating roller start revolving,
press “heating” button (5) and adjust the temperature to optimum value. (Default temperature is 220
℃
)
7.2.
When the machine reaches the preset temperature, let the thermostat stabilize the temperature for a
while. Check the transfer result with small piece of printed transfer paper and substrate. Adjust the
temperature with reference to the testing result of the transfer.
7.3.
Place the printed transfer paper and tissue paper (to prevent the contamination of blanket) in proper
position on working table and main machine. Feed the tissue paper first and collected by the shaft at the
rear. then feed textiles flatly. Lastly, feed the printed transfer paper to the machine evenly.
7.4.
Before transfer begins, push the pressure controlling plastics roller on the main machine to the blanket.
Be aware that the pressure on both ends should be the same. If the pressure is not the same, release the
pressure controlling roller and push again.
7.5.
When fabric and transfer paper comes out, attach the fabric to collecting rollers at the rear of the
machine or just drop on (19) Cloth pocket. Then, attach the transfer paper to collecting roller at the front
side of the machine under the table. So all materials can be collected automatically. The speed of
collecting transfer paper can be adjusted by the controller (8).
7.6.
During the working process, the transfer speed can be adjusted (by “6”) according to the vividness of the
print.
7.7.
When the transfer is finished, switch off the heating button to let the machine cool down. The operators
have to monitor the machine until the temperature drops to less than 100
℃
. Then, the operators may
switch off the machine. For special circumstances, the operators may switch off the main power supply
and heater simultaneously. The machine will cool down automatically and stop running after certain
intervals.
7.8.
When there is sudden blackout and the machine is working at high temperature, turn the hand wheel
immediately and insert heat proof materials between the tank and blanket so that the hot roller does not
burn the blanket.
