Three phase din rial meter
SDM530D
user manual
1.1 Safety instructions
Information for Your Own Safety
This manual does not contain all of the safety measures for operation of the equipment (module,
device), because special operating conditions, and local code requirements or regulations may
necessitate further measures. However, it does contain information which must be read for your
personal safety and to avoid material damages. This information is highlighted by a warning triangle
and is represented as follows, depending on the degree of potential danger
.
Warning
This means that failure to observe the instruction can result in death, serious injury or
considerable material damage.
Caution
This means hazard of electric shock and failure to take the necessary safety
precautions will result in death, serious injury or considerable material damage.
Qualified personnel
Operation of the equipment (module, device) described in this manual may only be performed by
qualified personnel. Qualified personnel in this manual means person who are authorized to
commission, start up, ground and label devices, systems and circuits according to safety and
Regulatory standards.
Use for the intended purpose
The equipment (device, module) may only be used for the application specified in the catalogue and
the user manual, and only be connected with devices and components recommended and approved
by Eastron Electronic.
Proper handling
The prerequisites for perfect, reliable operation of the product are proper transport, proper storage,
installation and assembly, as well as proper operation and maintenance. When operating electrical
equipment, certain parts of this equipment automatically carry dangerous voltages. Improper
handling can therefore result in serious injuries or material damage.
Use only insulating tools.
Do not connect while circuit is live (hot).
Place the meter only in dry surroundings.
Do not mount the meter in an explosive area or expose the meter to dust, mildew and insects.
Make sure the used wires are suitable for the maximum current of this meter.
Make sure the AC wires are connected correctly before activating the current/voltage to the
meter.
Do not touch the meter connecting clamps directly with your bare hands, with metal, blank wire
or other material as you may get an electrical shock.
Make sure the protection cover is placed after installation.
Installation, maintenance and reparation should only be done by qualified personnel.
Never break the seals and open the front cover as this might influence the functionality of the
meter, and will avoid any warranty.
Do not drop, or allow physical impact to the meter as there are high precision components inside
that may break.
Summary of Contents for SDM530D
Page 10: ......