EW-ECO SERIES OPERATION MANUAL
26
Eight, Phenomenon and exclusion
The emergence of the
phenomenon
Processing method
Thread stripping without
1
、
check the thread cutting depth, cutting marks too shallow for regulating
“ diameter ” smaller.
2
、
the line wheel pressure is not enough, need to adjust the “ into the line
wheel pressure regulating knob ”, the line wheel pressure.
3
、
the line wheel clearance is too large, need to adjust the “ into the line
wheel clearance adjustment knob ”, the line wheel clearnce is reduced to
a proper position.
4
、
stripping the first set is greater than or equal to 3.
5
、
the line wheel if there is dirt, required to be cleaned.
6
、
retreat knife set may be too large, should be appropriate to reduce the
retracting parameter ( reference value 00-10 ).
7
、
the next tool misalignment, please refer to chapter seventh section 2 test
chart 7-7 alignment condition.
Wire stripping without tail
1
、
check line tail cutting depth, cutting marks too shallow for regulating
“ diameter ” smaller.
2
、
wire wheel, the pressure is not enough, need to adjust the “ round round
pressure regulating knob ”, the line wheel pressure.
3
、
wire wheel clearance is too large, is required for the regulation of “ round
round gap adjustment knob ”, make the pulley gap is reduced to a proper
position.
4
、
stripping the first set is greater than or equal to 3.
5
、
pulley if there is dirt, required to be cleaned.
6
、
retreat knife set may be too large, should be appropriate to reduce the
retracting parameter ( reference value 00-10 ).
7
、
the next tool misalignment, please refer to chapter seventh section 2 test
chart 7-7 alignment condition.
Wire skin of severe
barotrauma
1
、
first judge barotrauma from inlet wheel or pulley, wheel pressing force to
be small.
2
、
contact with my company, the purchase of rubber tire.
Thrum peel line core cut of
several root
The “ diameter ” tone in 1 or 2, retry until notto hurt the line core.
Length of line, there is
greater than or equal to the
set length
1
、
the line wheel pressure is not enough, and sometimes thread stripping
without phenomenon, thread stripping on line is greater than a
predetermined length, regulating “ into the line wheel pressure regulating
knio ”, so the line wheel pressure.
2
、
dirt, pulley, required to be cleaned.
A wire inlet wheel clearance is too large, to adjust the “ into the line wheel
clearance adjustment knob ”, and a wire feeding wheel gap smaller.
