EASTMAN PACEMAKER, Instruction Manual & Illustrated Parts List

Page: 6 / 44

6
EASTMAN
EDGE
CONTR
OL
POWE
R
ON
OFF
AUTO
MANU
AL
OUT
IN
1
4
3
5
6
2
Setting Marker and Spreading
Place marker onto table, starting 1/2 inch from left edge of
blade on stationary catcher. This will allow 1/2 inch for
trimming of folds. Be sure marker lies straight and parallel
to edge of spreading table.
From right end of marker, measure to right 19 1/2 inches
and mark table. Place movable catcher into Pacemaker,
as explained in "Setup For Spreading". Move Catcher to
the right until right end of catcher base plate matches the
19 1/2 inch mark. This allow 1/2 inch for trimming of folds.
Clamp movable catcher in this position with C- clamps
provided. Disengage catcher from machine, mark section
in marker and remove marker from table.
Load and thread Pacemaker with piece goods as ex-
plained in "Setup For Spreading". Reset counter to zero.
Place end of piece goods under movable catcher pinbar.
Spread cloth by pushing machine down table while main-
taining edge control with hand wheels on front frame.
Drop Sizes
When spreading drop sizes, keep highest lay of goods at
stationary catcher end of marker and lowest lay of goods
at movable catcher end of marker.
If dropping sizes without using movable catcher; pass the
drop edge" by approx. one foot. Tip tuck blade up and
catch the slack cloth. Begin moving spreading back to-
ward stationary catcher allowing slack cloth to roll back
until it aligns with "drop edge". Hold or weight the fold of
cloth and continue spreading back to stationary catcher.
FAMILIARIZATION
Control Box
1. Power Light: Activates when Main Power (4) is on.
2. In/Out: Press to move Edge Control Platform in or out.
3. Auto/Manual: Sets Auto/Manual Edge Control Mode.
4. Main Power: Activates Power to all Circuits.
5. Circuit Breaker: (2 Amp): Edge Control Platform.
6. Circuit Breaker: (2 Amp): Edge Control Platform.
Machine
7. Transformer: For 220 volt Automatic Edge Control or
Quick-Cut only.
8. Edge Control Motor: Automatic Edge Control only.
9. Edge Control Roller Bearings: Shifter Groove in
Roll Bar fits over bearings for edge control.
10. Roll Brake: Adjust Knob for proper fabric tension.
11. Hand wheel
12. Edge Control Reflector and Sensor: Move Sensor
and Reflector to adjust edge of fabric lay. The
reflector must be square to sensing eyes for
proper operation.
13. Rear Upright: Roll bar rests in nylon roller.
14. Lifting Blocks: Lifts pinbar when in catcher.
15. Tuck Blades: Folds fabric at each end of spread.
16. Elevator Actuating Link: Lifts Tuck Blades when
actuated by catcher.
17. Safety Bracket: Rides under table edge.
18. Elevator Step Adjuster: Adjust in or out for elevator
step adjustment.
19. Elevator Release: Press to lower Elevator/Tuck
Blades.
20 Ply Counter: Counts number of plies spread.
21. Push Handle: Auto Edge Control only.
22. Control Box: Auto Edge Control only.
From
the
library
of:
Diamond
Needle
Corp