PROCESSOR Frequency
9B8948 – 15JUN98
7
Possible damage from electrostatic discharge.
ESD
[10] Remove the 4 SCREWS and the CONTROL BOX COVER for access to the SWITCHES inside.
[11] Place the TAB on the CONTROL BOX COVER in the SLOT on the PROCESSOR.
[12] Set the PROCESSOR to the correct frequency:
(a) Move SW02-1 to the “ON” Position for 50 Hz operation or “OFF” for 60 Hz.
(b) Check that the SWITCHES are in the “OFF” position:
• SW02-1
• SW02-3
• SW02-4
Note
The CONTROL BOARD can be moved to the other end of the CONTROL BOX. If the holes at one end are not used,
cover them with TAPE.
H164_0003HC
SLOT
H164_0003HCB
CONTROL
BOARD
TAB
CONTROL
BOX COVER
SWITCHES
