10
1
Turn Main Power "ON"
Note: Switching the main
power on will activate the
monitor and software.
2
In the "Table Length Menu" set "Load
End" by pressing the "Find Load End"
or "Teach Load End" buttons.
3
Set "Table End" by selecting the
"Find Table End", "Teach Table
End", or "Enter Length" buttons.
8
Press "Main"
(Bottom right corner)
Press "Settings"
(Bottom right corner)
Verify all settings and ply counts, then press "Main" again
9
Note: Begin from step 10 if returning to your Saber E-Series and the
power was not switched off.
Set the spread using "Table End",
"Teach",or "Spread Length".
Note: When "
Table End
" is selected
the machine will automatically use
the Table End as endpoint. To teach
"Spread Length", press "
Teach
",
manually drive the spreader to your
start point, and press "End". "
Spread
Length
" requires entering a distance
relative to the start position.
7
Note: "
Find Load End
", the machine
travels until the limit switch is triggered.
When using "
Teach Load End
", drive
the machine to where you want to be-
gin the table, then press "Teach Load
End".
