Eastey VS1620, User Manual

Page: 22 / 66

22 Operation
E-Stop or Emergency Stop
A red E-Stop button is placed centrally above the heat tunnel control
panel. In the event of an emergency, press the E-Stop button in. This
brings the heat tunnel to a halt in a way to avoid damage or
excessive film waste.
CAUTION! When the Heat Tunnel unit is stopped or turned off
it will require some time to cool to ambient room temperature.
Be aware of heat inside of the tunnel and hot surfaces, belts,
or rollers.
When the E-Stop is pressed, the heat tunnel conveyor motor and heaters are turned off,
but blower motors are allowed to continue to blow to allow the tunnel to cool down in a
way to prevent damaging heat concentrations. Depending on heat settings, the time
required for the system to cool down completely may vary.
To return the machine back to normal operation once the E-Stop has been pressed,
verify the emergency condition has been cleared, then press and turn the E-Stop button
a quarter-turn so it pops out to normal operating position.
Sealer Operation
Seal Time
Use the “Seal TIME” timer to set the seal time. The seal time is the amount of time that
the magnets will hold the seal head down on the film. The seal time may vary according
to the type of film in use.
When the seal bar frame is pressed down onto the film, it will
remain in position for the set time then automatically release. Do
not hold the seal bar down onto the film.
Ensure that the timer sliding switches are in the times one (X1)
and the second (Sec) positions. If the timing switches are in the
X10 and or the minute positions it will result in a ridiculous value
that is way out of operating range.
Attention! Move the “Seal TIME” switch in very small
increments.
Emergency Stop
E-STOP