14 Installation and Set Up
Aligning the Seal Head Limit Switch and Actuator
The seal head limit switch and limit switch actuator are located on the hinge upright
angle closest to the heat tunnel.
Attention!
Ensure the limit switch and cap screw that activates it are
aligned and the cap screw adjusted so that the head will
activate the limit switch when the front seal bar is
approximately one-eighth to one-quarter inch from the seal
surface.
Loading the Film
Load the new roll of shrink film onto the film roller under the product tray. Install the film
roll so the center fold is at the back of the machine (the operator side is considered the
“Front” of the machine).
To load a roll of film:
•
Lift the shrink film roller off the roller mounts located beneath the product tray.
•
Loosen the locking knob on one of the film cores and slide it off the roller.
•
Install the new roll of shrink film onto the film roller.
•
Reinstall the film core.
•
The film position is adjustable. Loosen the film core retaining collar lock knobs and
position the shrink film roll according to the product size. Retighten the retaining
collar locking knobs.
Cap
Screw
Limit
Switch
View
Summary of Contents for Value VS1620TK
