12 Installation
The locking casters allow the taper to be moved easily over a smooth flat surface. If the
unit must be lifted to move it to the desired location you will need to use a pallet jack,
floor crane, or fork lift to lift it.
Location Requirements
When installing the SB-2/3EX Standard Case Taper please be aware of the following
considerations:
1. The mounting surface is flat and level.
2. Conveyor or packing table height.
3. Alignment with packaging line.
When the SB 2/3-EX Standard Case Taper is positioned in the operating location you
will need access to:
1. The power switch.
2. Height and width adjustments.
3. Tape loading (Both upper and lower tape cartridges).
Roller tables are provided standard at both the in-feed and exit ends of the case taper.
A packer can fill boxes and close the flaps at the in-feed roller table before feeding
boxes into the case taper, and then pick up boxes that have been sealed from the exit
roller table.
If the case taper is part of a longer packaging line, take into consideration the table and
conveyor height in relation to adjacent machinery.
It is essential that the table and conveyor be at the machine bed height.
The machine should be placed on a flat, level floor so that it does not rock or move. We
recommend that the machine be securely locked in place when used.
Summary of Contents for SB-2EX
