Eastey SB-2 HD, User Manual

Page: 15 / 44

Installation and Setup 15
Loading the Tape Cartridges
Turn the main power off and disconnect power.
CAUTION! To avoid personnel injury, remove the tape cartridge before
loading tape.
When handling the tape cartridge be careful to avoid contact
with the tape cutting blade.
Lower Cartridge
To remove the lower tape cartridge, it is necessary to raise the upper taping head to the
highest position. Loosen the height adjust locking knobs (there is one on each side of
the vertical mast supporting the tape head seat) and raise the upper tape head. Re-
tighten the locking knobs.
After raising the top taping head up, remove the lower taping cartridge from the bottom
section by holding both lift points and lifting leading with the rear lift point first, raising
the tape cartridge upward, out of the lower tape head seat.
Height Adjust
Locking Knob —
One Each Side
Of Vertical Mast