Adjustments 21
Guide Rail Adjustment
The purpose of the guide rails is to guide the box into the center of the machine as it is
fed into the conveyor from the in-feed table. Keeping the box centered on the conveyor
keeps the tape heads centered with the box, which keeps the tape seal on-center as it is
applied to the box on the top or bottom seams.
To adjust the guide rail width, loosen the hand knob below the in-feed table on the leg
on the side opposite the mast. Guide rails are mechanically linked so they will both
rotate equal distance as they are adjusted. Move the guide rails to the width required for
the box, and then retighten the hand knob with the guide rails in the new position.
Guide Rail Adjustment
Hand Knob
Summary of Contents for BB-2T
