IP
SPEED
DOME
CAMERA
■
Please read this instruction carefully for correct use of the
product and preserve it for reference purposes.
■
All the examples and pictures used here are for reference
only.
■
There may be several technically incorrect places or printing
errors in this manual. The updates will be added into the new
version of this manual. The contents of this manual are subject
to change without notice.
1. Interfaces and Parts
①
LAN
②
HP Audio Out
③
MIC In
④
Alarm
In/Alarm Out
⑤
Power
◆
Install SD Card
◆
Install the Speed Dome
A
larm
Connection
:
1. Alarm
Input
a) There is one independent alarm input port (ALM-IN1) and
one grounding port (ALM-GND).
b)Alarm input(NO type): Connect DC5V~DC12V voltage
between the alarm input port( ALM-IN1) and the grounding port
(ALM-GND).
c) Alarm input(NC type): Disconnect the voltage between the
alarm input port(ALM-IN1) and the grounding port (ALM-GND).
2. Alarm
Output
a) Support 1CH alarm output including OPEN, COM
connections.
b) Alarm output: One passive switch for user to connect alarm
devices; the alarm output state will be auto on/off according to
your setting.
2
3
2. Installation
Please make sure the wall is strong enough to bear the dome
camera’s weight.
Please make sure the camera is powered off
during installation.
3. Connections
②
Loosen the four screws of the back cover
of the dome.
①
Pull out the rubber plugs and then
loosen the screws under the rubber
plugs to remove the side covers .
③
Open the back cover and insert SD card.
③
Drill the screw holes on the wall according
to the drill template. Then insert the plastic
plugs into the holes.
⑤
Connect
the
cables
and
then
hang
the
bracket
on
the
wa
l
l
.
⑥
Fix
the
bracket
to
the
wall
with
four
screws.
④
Drive the two screws to the holes indicated
by the arrows (left) and leave 12mm
clearance.
④
Install the back and side covers. The reset
hole in the back cover must be aimed to the
reset key of the mainboard when installing
the back cover.
4. IE Network Connections
In
LAN, there are two ways to access. a. Access through
IP
-
Tool; b. Directly Access through IE Browser
1
①
Pull the cables through the bracket. Mount the
speed dome to the bracket.
②
Secure the speed dome to the bracket with
the screws.
Quick Start Guide
Insert
SD card
●
Access the camera through IP
-
Tool
①
Make sure that the camera and the PC are well connected
to the LAN.
HP
Au
dio O
ut
Ne
tw
ork P
ort
MI
C I
N
Power
TF
Card
Side
Cover
Rubber Plug
Rubber Plug
Reset
1
2
3
4
5
ALM-OPEN
ALM-COM
ALM-GND
ALM-IN1
24V
A
24V B
Earth
DC24V
AC24V
Note: DC24V and AC24V power supply
are optional. Please take real camera as
standard.
②
Find the IP-Tool from the CD and then install it in the PC.
After that, run the IP-Tool as shown below.
