Router /
LAN Switch
Computer
5VDC--2A
LAN
PC
Adapter
MATRIX COMSEC
Head Office
394-GIDC, Makarpura, Vadodara - 390010, India
Ph:+91 265 2630555
E-mail: [email protected]
www.MatrixTeleSol.com
Version 1, December 2015.
4.
5.
Connect the Headset (not supplied by Matrix)
If you want to use a Headset,
Ÿ
Plug any standard stereo headset with 3.5mm single connector into the
headset jack on the left side panel of the phone, marked with the symbol .
Ÿ
You may also plug in a headset with RJ9 connector into the headset port on
the left side panel of the phone, marked with the symbol .
6.
CONNECT
Step 2
Handset
Headset
Headset
Stand attached at
35 degree angle
Stand attached at
50 degree angle
Ÿ
You can attach the Foot Stand in the following ways - at an angle of 35
degrees and 50 degrees.
STARTUP AND OPERATE
Step 3
Ÿ
When the IP Phone is connected to the network and supplied with power, the
booting process initiates.
Ÿ
After loading the application, the phone obtains the Network Settings,
updates the Firmware (if required), obtains the Configuration and then
attempts to register.
Ÿ
To configure and register the phone as a SIP Extension, refer to the
System Manual
. For operating instructions refer to the
EON48_310_SPARSH VP248_310_User Guide
.
The documentation can be
found at
http://www.matrixtelesol.com/technical-document.html
Connect the IP Network
Ÿ
Connect the LAN Port of the phone to the IP Network — A Router or LAN
Switch — using the Ethernet Cable.
Connect the Power Supply
Ÿ
Plug in the connector of the Adapter provided with the phone into the power
jack (DC Jack) with the label 5VDC-2A at the bottom of the phone.
Ÿ
Plug in the Power Adapter into a power outlet.
Ÿ
PoE enabled phone can be powered over Ethernet by connecting it to a PoE
enabled LAN Switch (IEEE 802.3af Compliant). In this case you need not
connect the Power Adapter.
Note: If both the power options, that is, PoE as well as Power Adapter are
available to the phone, then the phone will derive power from the PoE
enabled LAN Switch.
Connect the Handset
Ÿ
Connect the handset of the EON310 to the phone body using the Spring
Cord (supplied with the phone).
Ÿ
Connect the long straightened end of the Spring Cord into the RJ9
connector on the left side panel of the phone, marked with the symbol .
Mount SPARSH VP310 on the Desk
Connect a PC to the Phone
Ÿ
Plug in the Ethernet Cable into the PC Port of the phone and the other end into
the LAN Port of your PC.
