The Phoenix Forge Owner’s Manual
Make Sure Nothing Flammable is Near Your Phoenix Forge! Only Operate the Forge in a Safe Area!
About Your Phoenix Forge:
Thank you for choosing our work! Your forge is a simple to operate tool that has a dual lined chamber and
Stainless Steel Body. It was designed to totally accommodate any smith in need of a simple, small, no frills
tool that can handle flux and forging as a forge should. The Phoenix arrives as a
“
plug and play
” tool
. Simply
follow the instructions in this manual and turn it on. There is no assembly.
Funny Fact:
We made this forge because we couldn’t
buy it. Plain and simple. Much of
the “forges” on the
market seem to be little more than
“
DIY
” kits aka
unsafely lined chambers that come with packets of cement
for the user to line the forge with. The only other forges are soft fire brick forges and those can’t handle flux
They also tend to crack due to heat stress.
The chamber is 4” wide and 12” deep wi
th both ends open to the atmosphere. One end can be blocked with
bricks if desired. The forge is perfect for knives, most swords and small tomahawks. We use our forges every
day and we expect you to be able to do the same.
Your forge is made in America. And it always will be while we make them.
Note:
The burner we use was designed and released into the public for free use. We have always known it as the
Frosty “T” Burner. It is Bear’s favorite burner and one we have used for many years. It was origi
nally designed
by Frosty the Lucky.
A shout out of gratitude goes to Custom Firescreen of Des Moines, Iowa for helping to develop and produce
the forge bodies for The Phoenix. We could not do this without them.
