4.
To obtain a higher cut remove the height adjustment spacer (s) from the impeller hub.
Remount the cutter disc to obtain the highest cut - do not use any spacers. Install the f lat
washer and the Impeller retaining bolt. Tighten the bolt securely. (Fig 14)
5.
a.
Remove the height adjustment spacer (s) from the impeller hub. (Fig 14)
b.
Remount the cutter disc.
c.
Install the f lat washer and the impeller retaining bolt.
d.
Tighten the bolt securely.
e.
To obtain the maximum cut height, do not use any spacers.
f.
Use a 3” long Impeller retaining bolt when no adjustment spacers are used.
Figure 14
1. Impeller
3. Impeller Flat Washer
2. Cutter Disc
4. Impeller Retaining bolt
5. To obtain a lower cut add height adjustment spacer (s) between the impeller hub and the
cutter disc. Remount the cutter disc. Install the f lat washer and the impeller retaining bolt.
Tighten the bolt securely. (Fig. 15)
a.
Add height adjustment spacer (s).
b.
Remount the cutter disc.
c.
Install the f lat washer and the impeller retaining bolt.
d.
Tighten the bolt securely.
e.
Use a 3 ½ ” long impeller retaining bolt when one or two ½” spacer (s) or 2 or more ¼”
spacers are used.
Figure 15
1. Height Adjustment spacer
Summary of Contents for Hover Mower HM19H-4
Page 1: ...Model HM19H 4 Model HM19H 4 OP Operator s Manual...
Page 24: ...MOWER PARTS HM19H 4...
Page 26: ...MOWER PARTS HM19H4 OP...
