b
a
Assembly
2
Final assembly
Push the lower dowels into the holes at the bottom of one of the end panels.
Fit the upper dowels and straps so that the straps lie across the TOP of the dowel as shown
in illustration b above.
Once all dowels are fully inserted into one end panel, attach the second end panel.
Ensure that the dowels are fully inserted into each end panel and stand the cradle upright
to check that the end panels are aligned with each other.
When the panels are aligned, secure using the 8 large screws as shown. Tighten the
screws to the point where the flat head of the screw is in full contact with the frame. Do not
over tighten.
In use
3
To stop the stand from rocking, fold down the stop on each end frame of the stand.
Attach the plastic tubes.
Take the two plastic tubes and insert them into the upper holes in the end Frames.
(Diagram a).
Ensure that they are pushed fully into the holes and secure using the four small screws as
shown.
Introduction
1
This product meets the requirements of
BSEN 1466:2014
This stand is designed for a crib with maximum dimensions of 800mm x 320mm and
minimum of 6
9
0mm x 270mm.
IMPORTANT. READ THE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP FOR FUTURE
REFERENCE
c
