EAS Electric EMF1970AW1, Instruction Manual

Page: 40 / 43

4.4 How to take out the humidity controlling glass shelf
Please don'! try to the take out the humidity controlling glass shelf, lf it needs to be removed due to
cleaning or other reasons, please fallow the steps as shown as below:
1 )Open the door of refrigerator room, hold the upper right comer of door gasket, pull it outwards
smoolhly until il is separated from the upper right comer of door liner, then hold the upper side and
right side of door gasket and pull the gasket outwards until the gasket is separated from the door;
2)Take out !he two fruit and vegetable boxes;
3)Remove !he fixing tape on the backside of humidity controlling shelf, then use hand to push !he
backside of glass upwards,until the backside is separated from !he shelf frame with about 1 O
º
, and
take out the glass with tremendous care;
4)Hold the front edge of humidity controlling shelf and lifl up il about 20
º
,then take out the humidity
controlling shelf;
5)The reverse operation is far assembly;
NOTE:
far gasket assembly, please press the upper right comer of gasket into the upper right comer
of door liner, then press the upper side and right side of gasket into the door liner, finally to press the
left side and lower side of gasket into door liner. After completing the assembly, please check wether
the assembly is firm or not(try to pull out the gasket gently to check), and make sure !he surface of
gasket is flat.
4.5 Out of operation
• Power failure: In case of power failure, even if it is in summer, faods inside the appliance can be
kept far several hours; during the power failure, the times of door opening shall be reduced, and no
more fresh faod shall be pul into the appliance.
• Long-time nonuse: The appliance shall be unplugged and lhen cleaned; then the doors are lefl
open to preven! odor.
• Moving: Befare the refrigerator is moved, take all objects inside out, fix the glass partitions,
vegetable holder, freezing chamber drawers and etc. with tape, and tighten the levelling feet;
clase the doors and fix them with tape. During moving, the appliance shall no! be laid upside down
or horizontally, or be vibraled; the inclination during movement shall be no more than 45
º
.
The appliance shall run continuously once it is starled. Generally, the operation of
the appliance shall not be interrupted;otherwise the service life may be impaired.
)
16
V.1