2 SR25 Cardioid Microphones (overheads)
4 DM20 DrumMic™ (toms & snare)
1 SR20LS (kickdrum)
4 RM1 RimMount™ (for DM20s)
3 SRW3 Foam Windscreens (for SR25s & SR20LS)
4 PW1 Windscreens (for DM20s)
1 High Impact Carrying Case with custom foam insert
YOUR PURCHASE INCLUDES
Thank you for purchasing the
Earthworks DK7 DrumKit™!
Before setting up the microphones, pull back all existing settings and EQ. By doing this, you will have a
baseline understanding of how our microphones sound, and will then be able to adjust accordingly.
Begin by removing all included components from the packaging. Make sure to mute any incoming
signal to speakers or headphones to avoid any loud “pops” when connecting.
Connect the microphones to an audio interface supplying 24-48V phantom power using a standard
XLR cable. Please allow one minute for the microphones to settle. (Plugging in the microphone while
phantom power is turned on will not damage the microphone, and will actually settle the microphone
faster.) For the SR25s and SR20LS, complete the setup by placing them with their respective clips on a
microphone stand. For the DM20s, there are some additional steps:
Insert the DM20 Microphone into the RM1 RimMount
Place the mic head and the gooseneck into the rubber holder from the bottom of the RimMount™.
Push on the body of the microphone from the bottom (XLR connector end) to move the microphone
up inside the rubber holder. The fit will be firm, so you will need to apply a little pressure to move the
microphone body up until it stops naturally at the logo ring.
The RM1 is designed specifically for the DM20 allowing you to mount the microphone on the side of a
tom or snare. The RM1 can also be used on the top or bottom of a tom or snare. It is suggested that you
insert the DM20 microphone into the RM1 RimMount™ prior to attaching the RimMount™ to the drum.
Mount the RM1 RimMount™ to the Drum
Place the mic head and the gooseneck into the rubber holder from the bottom of the RimMount™.
Push on the body of the microphone from the bottom (XLR connector end) to move the microphone
up inside the rubber holder. The fit will be firm, so you will need to apply a little pressure to move the
microphone body up until it stops naturally at the logo ring.
The RM1 is designed specifically for the DM20 allowing you to mount the microphone on the side of a
tom or snare. The RM1 can also be used on the top or bottom of a tom or snare. It is suggested that you
insert the DM20 microphone into the RM1 RimMount™ prior to attaching the RimMount™ to the drum.
(Setup instructions continue following Product Specifications.)
GET TING STARTED
SET TING UP THE DM20
